Autoclave For Synchronous Belt / V belt
This unit is mainly used for Vulcanize | Cure the drive belt (V-Belt, Timing Belt,Ribbed V-belt etc) sleeve after molding.
- Vertical hydraulic or Pneumatic cycling, Cover-lifting, Cover-rotary, Vertical hydraulic or Pneumatic cycling,
- The piping system and the electrical system are designed by focusing on the pressure in the pot, constant temperature,
small vibration, release the over steam, low temperature drainage and no water in the pot.
- The equipment is equipped with PLC, text operation, touching screen, automatic cutting valve, pneumatic film adjusting valve,
pressure transmitter, temperature transmitter and temperature sensor.
- The whole working process is superivised. The parameter of temperature, pressure time etc are controlled accurately
which make sure the stable quality.
-Mold height: 1000/500 mm
-Inside diameter: 1800/2000mm
-Working pressure: 1.4/2.1Mpa
-Working temperature: 195